Step 4 – Move to Level – Once it is settled you have achieved a level point between both ends of the tube, you can then move it up or down until the fluid meets the height required. The other end of the pipe will be at the same height. You can then place your mark Fresh water tank probe is supplied with a gasket and mounting nut for fitting to a 60mm diameter hole in your water tank and the wiring harness connecting the probe to the test panel is 4m long. A water level is exactly what it sounds, it’s a form of level that utilises a principle of physics that water will always find its own level wherever it is placed. Tip water onto an uneven floor and it will always find the low spots for you. Note: If using with tanks of a shallower depth than 400mm, the probe can be cut down to suit as follows:

To save the job of making your own, you can actually buy a pre-made water level from most DIY stores such as the one below. However it is likely that it will cost a bit more than making one yourself. A complete leak detection kit to help protect a basement area or other vulnerable area in the home such as laundry rooms, central heating systems or other water pipes, from unexpected water leaks. Including a LeakStop alarm panel, connection cables, 3 metre sensor tape and optional shutoff valve (sizes available between 1/2″ and 2″).Hold the hose ends at the same height. Allow the water level to equilibrate freely. Mark both levels of the surface of water on the hose.

Step 2 – Prepare Water – Fill A suitable sized jug with water and add several drops of food colouring to to dye it. This will help to make it more visible in the tube

Documentation

In case of water loss, refill and adjust the device. Colours on images on different devices may vary. We cannot guarantee an exact match of the colour to the product. Our collections by our couriers are happening as usual. As it stands, delivery times are not being affected too much. Please be aware though that Royal Mail and other couriers are sometimes prioritising essential items so please bear with us if your delivery takes slightly longer than expected.

Toolty Water Level Gauge Kit is used for leveling points that are far apart. Measuring tubes with a readable scale are made out of durable plastic (PVC). Tight plugs prevent the outflow of water at the place of measurements. When it comes to making your own water level, the type of tube is of high importance. You will need to ensure that it’s the correct length for your needs, so 50 – 70 feet should suffice and a diameter of 8 – 10mm will give enough movement for the water and allow a level to be clearly seen. Step 2 – Hold to Second Object – Holding your finger over the top of the tube, take the other end down to the object where you need to mark a level and hold in a "near enough" position towards the top of the object Step 1 – Fix to First Object – First, hold the tube up to the first object and then using either tape or screws, tape it or position screws either side to hold it in place so the top of the tube is level with the top of the object

Yes, you can continue to return items as normal as long as you follow the government guidelines about leaving your house.