Apply a final gentle spray of water across the surface towash off any EASYJoint residue and to aid the final compaction process. Aquacut Aquacut Limited has a dedicated team of craftsmen with decades of experience processing a wide range of building materials such as porcelain, stone, metals, glass, and composites to create functional and beautiful building finishes.

In terms of application, there is not so much need to use copious quantities of waterwith porcelain as the EASYJoint will not cause it to mark in the same way it can with stone or concrete. The same rules apply when working with porcelain paving tiles as with working with stone or concrete.With no need to mix, this compound is quick to brush in and perfect to use alongside various forms of paving material. Some cookies are essential to the functioning of this site whereas others are non-essential but help us provide a better browsing experience. When you clean the patio hold the power washer at an angle of about 45⁰ degrees and using a fan spray from no closer than 150mm from the paving joint.

The result of using EASYJoint, to joint your paving, will be a paving gap that is completely filled without the need for kneeling and compressing the material by hand that will last for years. EASYJoint is designed for use with permeable, free draining sub-bases, which allow water to pass through. Utilise the same method when working with porcelain paving tiles as with working with stone or concrete. Freezing conditions are not always problematic for EASYJoint, however the volume of water used during the application process can potentially freeze.

As well as the options provided below, you can choose to restrict or block cookies through your browser settings at any time. A strong joint that will resist the elements and stand the test of time - better than traditional jointing methods. If the desired effect is to have a more colourful, striking patio, then buff sand is a good option to keep an injection of colour present. The paving joints are then completely filled without the need to kneel down and compress the grout into the joints by hand, saving your back and saving time!

To achieve it, create a channel in the base material by running the tip of a trowel around the exposed edges of each paver to create 25mm depth for EASYJoint to sit in (see illustration above). This will assist in checking for low spots whilst ensuring the joints are uniformly below the surface of the paving. Driveway Jointing Mortar - High Strength Epoxy Resin Paving Grout - suitable for vehicle areas up 3. They offer the best possible combination of advanced technological formulations and environmentally friendly raw materials.It will also allow any efflorescence or natural salts present in the sub-base and substrate to pass through the paving material and wear off naturally over time.

Particularly sensitive, porous stone should always be sealed on both sides and all edges as a precaution. Clean out the old jointing product completely to create the correct joint size (see information under the ‘Joints’ section).Any extra or unused compound can be placed back in the tub with at least 50mm of water which will be safe to use again within 12 months of storing. Some concrete paving is made in moulds and has chamfered edges creating a ‘V’ shaped joint between two paving slabs, wider at the top than at the bottom. EASY Joint will always go rock hard as soon as it is in contact with the air, it does not need water to cure. Once EASYJoint has set hard in the joints, sweep the paving with a stiff broom, diagonally to the joints, to remove any final traces of compound, especially along the edges of "struck" joints. Our instructions state that any sagging of a joint must be topped up whilst it is still wet (or has not cured).